Edge Pro

EP-600_UM

Edge Pro 600 Grit Sharpening Stone, Unmounted

16 items left

Use this 600 grit sharpening stone for achieving an extra fine edge on your knives. Unmounted whetstones stones must be mounted to a stone blank (sold separately) to be used with the Edge Pro sharpening systems. Pro sharpeners and home enthusiasts who go through many whetstones stones can remove their worn out stones from the existing stone blank and mount these unmounted stones themselves for a considerable savings. EdgePro suggests mounting the stones using 3M's Super 77 adhesive spray. 

Please note that unmounted stones are very thin and so very fragile. We wrap them carefully in bubble wrap so they'll make it to you in one piece, but you must exercise extreme care when unwrapping and mounting them. We are not responsible for broken or cracked stones during or after mounting, nor during use.

Customer Reviews

Based on 1 review
100%
(1)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
E
E.
Great option to save a bit of money if you are handy.

My stones arrived very well wrapped in foam sheeting. To remove the old stone you can gently grab it in a vice on the aluminum and heat it from the bottom with a blow torch to loosen the glue. If that seems dangerous you can also put it in a pot of boiling water for a bit then remove it with tongs and scrape the old stone and glue off with a scraper of some kind.

To mount the new stone 3M Super 77 spray adhesive is what is recommended and what they use at Edge Pro. Putting paper or cardboard under the stone and blank to catch overspray is a good idea. Spray both the back of the stone and the aluminum blank lightly then wait 15-30 seconds for it to get tacky and press the stone and aluminum base together. Be careful to line them up fully before pressing together. Put something protective like waxed paper over the stone and set something like a decently heavy book on top for a few minutes while the glue bonds and cures.

Sign up for our Newsletter & Save!