A traditional style Deba (fish butchering) knife, handmade in the Moritaka workshop. Note that unlike most other Moritaka knives, this one is indeed very thick, but it is still pretty much 50/50 bevel and so generally fine for right or left hand use. Blade is made of Aogami/Blue Super carbon steel, with a permanent walnut wooden handle and a stainless steel tang. These blades can take a super sharp edge and the added toughness of the Blue Super steel should help with edge strength and resistance. The finish is kuro-uchi (black) with a lacquer coating -- this helps protect the steel and should not be polished off, though it will eventually wear off over time and this is normal and to be expected. Being made of very hard carbon steel, this knife WILL be more fragile than other knives, especially stainless steel knives, and as such you are responsible for proper knife handling and care -- edge damage is never covered under any warranty. Comes packed in a nice cobalt-blue box.
NOTE: Handle colour/finish may vary from the version pictured here. It is natural wood, and so some are lighter or darker than others, and small imperfections are to be expected and are not considered defects.
IMPORTANT: Moritaka knives are very sharp and high-performance knives. To achieve this, the edges are ground very thin, and the steel is very hard. This results in a knife that is potentially fragile. As such, CHIPS OR CRACKS TO THE EDGE OR TIP ARE NOT COVERED UNDER ANY WARRANTY. It is the nature of such a knife that it is potentially fragile. If you are a beginner, not confident in your knife handling skills, or looking for an all-purpose knife, do NOT purchase this knife. I love my Moritaka and use it almost daily, but I only use it for precision slicing, dicing, and mincing (great for onions, garlic, ginger, boneless meats) as I’ve certainly chipped edges on other high-performance Japanese knives over the years, so I know it's always a risk. It is important to NOT use a rapid up-down rat-a-tat style chopping motion (where you are smacking the edge down rapidly on the cutting board). While cutting also remember to use good controlled technique -- hard steel will not tolerate "tweaking" (any sideways twisting) and just like any hard material this can result in a chip or crack. You should let the knife do the work, and not lean down and apply pressure to the edge. Cutting surface is also important: only use plastic or maple, NOT bamboo, stone/granite or glass. I also only recommend using these knives with boneless meats and regular veggies (onions, garlic, ginger, etc.) -- never hard/tough materials like root vegetables (turnips, etc.) and certainly nothing where you'd hit a bone. Finally, since they are made of carbon steel, do NOT try to keep the knife shiny. Think of it like a carbon steel crepe pan or a cast iron pan, which both benefit from a "seasoned" finish which will develop a natural yellowish discoloured patina. This is normal and will help protect the carbon steel from rusting. Do not leave these knives in a sink or sitting in water. After use, wash with warm soapy water, dry well, and store in a wooden knife block (do not store in a drawer or on a magnetic knife holder). So in conclusion, yes, this is a high-performance knife, but as with any high-performance tool or machine, this means it requires extra care and skill. A Ferrari will require MORE care, skill and maintenance than a Toyota Corolla, not less.